High precision anticorrosive low cost water purifier sensor

Product description

After installation of automatic water purifier, the strength test pressure and tightness test pressure (i.e. design pressure) of all equipment shall be carried out according to the pressure marked on the equipment nameplate. The test medium is clean water, and the test time is 30min. It is qualified to check that the equipment has no leakage, no pressure drop, no damage and no visual deformation. Automatic water purifier pressure test system must be installed with two pressure gauges (i.e. one at the highest point and one at the lowest point), the highest pressure gauge reading shall prevail. The measuring range of the pressure gauge is 1.5-2 times the maximum pressure of the test system, and the accuracy is 1.5 class. After the automatic water purifier equipment is installed and tested, it should be drained in time and the compressed air should be dried and sealed in the equipment. The pressure test of automatic water purifier should be carried out in accordance with the above methods to ensure that the pressure test is correct and no problems can be used after the test, so as to reduce the occurrence of problems in later use. Specializing in the manufacture of gas differential Pressure Transmitter, Oil Pressure Sensor, Water Pressure Sensor, air compressor pressure transmitter, wall mounted furnace Pressure Sensor, Water Purifier Pressure Sensor, high precision pressure sensor, etc.