Product description
Water purifier common faults and treatment methods: water purifier does not water :1. Water purifier does not water. Check whether the water and electricity are normal. 2. Check whether the high pressure pump is running and whether there is waste water. If there is waste water, there is no problem with the intake and drainage systems. Check valve stuck, no pure water flow out of the faucet; Whether the filter element is scrapped in advance, or has reached the service life, water is not smooth or not water; There is no blockage elsewhere. 3. If there is no waste water, check whether the water inlet solenoid valve cannot be opened and the water cannot pass through. In addition, check whether the filter element is blocked until the replacement cycle. 4 pump does not turn, no water, check whether the filter element is blocked, whether the motor is damaged. 5. The circuit is abnormal. Check the circuit. Water storage bucket full, but not off: check the high pressure switch, whether the pressure is too high, if too high, adjust to 2.8-3Mpa. In addition, the inner corner bolts of the high pressure switch can be adjusted. The inner Allen wrench can adjust the pressure by 2mm clockwise, and vice versa. The pressure is not large, the pressure is too large, the water pressure will increase accordingly, so the wastewater will also increase, the indirect reaction pressure of the high pressure pump, less than 0.3Mpa, the high pressure pump pressure is not enough, the normal should be 0.5-0.8Mpa. Specializing in the manufacture of Water Purifier Pressure Sensor. Specializing in the manufacture of gas differential Pressure Transmitter, Oil Pressure Sensor, Water Pressure Sensor, air compressor pressure transmitter, wall mounted furnace Pressure Sensor, water purifier pressure sensor, high precision pressure sensor, etc.