New products can be customized water purifier sensor

Product description

Household water purifier common fault maintenance treatment method: water purifier water production smaller. Solution :1. If the intake pressure is too low, it can be supercharged. 2. The inlet water temperature is too low. When the temperature drops, the amount of water produced decreases, which is normal. 3. If the inlet flow is too small, the inlet flow can be increased or pressurized. 4. Excessive impurities in the water will increase the pretreatment or flushing frequency. 5. After the water is cut off or the maintenance pipe is closed, the residual sand and rust in the pipe must be washed away before the water is discharged. Specializing in the manufacture of Water Purifier Pressure Sensor. The discharge from the water purifier is cloudy. Solution :1. The inlet pressure is too high or fluctuates too much, resulting in breakage of the ultrafiltration membrane (replace the ultrafiltration element). 2. Reinstall the leaked O-ring on the ultrafiltration membrane (replace the O-ring). 3. High Fe2 and Mn2 ions in raw water (adding pretreatment to remove iron and manganese). Specializing in the manufacture of water purifier Pressure Sensor. Specializing in the manufacture of gas differential Pressure Transmitter, Oil Pressure Sensor, Water Pressure Sensor, air compressor pressure transmitter, wall mounted furnace pressure sensor, water purifier pressure sensor, high precision pressure sensor, etc.