Cheap and practical engineering professional sensor

Product description

In order to determine the number of pressure sensors and the specific installation position of the hydraulic system, it is necessary to consider the various charging sections of the charging network. It must be installed along cables and cable joints. Install at least four pressure sensors on each cable. The distance between the two pressure sensors near the telephone office is not less than 200mb. Start to install a cable, end to install a cable. Install a branch point for each cable. When the two branches are close together (less than 100 meters), only one branch point needs to be installed. When the cable laying method is changed (overhead or underground), one cable should be installed. For cables without branches, the distance between pressure sensors must be no greater than 500m, and the total number of pressure sensors must be no less than four, because the wiring scheme of basic cables is the same. In order to facilitate the determination of the fault point of the Pressure Sensor, in addition to the installation at the starting point, 150~200m away from the starting point, but also another installation of 1. Of course, in the design, must consider economic and technical factors, in the place that does not need to install, it is not suitable to install. Specializing in the manufacture of Urea Pressure Sensor, common rail Pressure Transmitter, engineering hydraulic sensor, injection molding machine special pressure sensor, water purifier pressure transmitter, etc.