Analog Sensor Water Purifier Pressure Sensor

Product description

Water purifier fault and solution :1, check whether the power is off, plug is inserted. 2. Check whether the low-voltage switch is faulty and cannot be powered on. 3, check whether the water pump and transformer short circuit, or the whole machine line connection is wrong. 4. Check whether the high pressure switch or water level controller is faulty and cannot be reset. 5, check the computer box (referring to the microcomputer) whether there is a fault. Two, high pressure pump works normally, but can not make the water :1, high pressure pump pressure loss. 2. The water inlet solenoid valve is faulty, and water cannot be imported (neither pure water nor wastewater)(whether to reverse). 3. The pre-filter element is blocked (no pure water or less waste water). 4, check valve failure (no pure water wastewater). 5, automatic flushing solenoid valve failure, can not be effectively closed (has been in the flushing state). 6, the computer case has a fault can not close the recoil solenoid valve (has been in the state of washing). Three, high pressure pump non-stop :1, high pressure pump pressure is insufficient, can not reach the high pressure set pressure. 2. Check valve is blocked and pure water is not discharged. 3, high pressure failure, can not jump. 4. The solenoid valve is faulty and cannot be opened effectively. Specializing in the manufacture of Water Purifier Pressure Sensor. Specializing in the manufacture of Refrigerant Pressure Sensor, common rail Pressure Transmitter, engineering hydraulic sensor, water purifier pressure transmitter, etc.