Product description

Installation of pump Pressure Sensor includes process connection and signal line connection to power supply. The selection device for mounting the pressure sensor is preferably in the straight section, as far away from the pump, shut-off device, elbow and other elements of the line as possible. In addition, when routing power cables and signal cables, ensure that no condensate water enters the sensor cable inlet. Also, it is important to use shielded cables if installed near these locations. Lay a communication line for a Water Pump Pressure Sensor with a capacity greater than 0.5kW. To measure gas pressure, the sensor must be mounted at a 90° Angle from above near the main line. Also, if this is not possible, the connecting tube must have a unilateral slope (at least 1:10 or ~ 6°) from the pressure output point to the sensor. If the sensor cannot be installed at the top of the line, the settlement vessel should be installed at a lower position. Collect condensate in connecting pipe. In addition, a single - sided inclined pump pressure sensor is required. Specializing in the manufacture of water pump pressure sensor, intake manifold absolute pressure sensor, Hydrogen Energy Pressure Sensor, refrigerant Pressure Transmitter, air conditioning pressure transmitter, etc.