Technology leading pump pressure sensor measurement range

Product description

How to install the Water Pressure Sensor: Check the dimensions of the mounting holes. If the mounting hole size is not appropriate, the threaded part of the Pressure Sensor is prone to wear during installation. This will not only affect the sealing performance of the equipment, but also make the Pressure Transmitter can not play a full role, and may even produce security risks. Keep the mounting hole clean. It is very important to keep the installation hole clean, prevent the plug of molten material and ensure the normal operation of the equipment. Before cleaning the extruder, all pressure sensors should be removed from the extruder barrel to avoid damage. When the pressure sensor is removed, molten material may flow into the mounting hole and harden. If this residual molten material is not removed, the top of the sensor may be damaged when the sensor is reinstalled. Cleaning tools will remove molten residue. Choose the right location. When the Water Pressure Transmitter is installed too close to the upstream of the production line, unmelted material may wear down the top of the sensor; If the sensor is installed too far back, there may be a stagnation zone between the sensor and the screw stroke of the molten material, at this time the molten material is likely to degenerate, the pressure signal may also transfer distortion; If the sensor is too deep in the barrel, the screw may touch the top of the sensor when rotating, causing damage to the sensor. In general, the water pressure sensor can be mounted on the barrel in front of the filter, on the front and rear of the melt pump, or on the mold.