Can customize parameters of engineering hydraulic sensors

Product description

When installing a Hydraulic High Pressure Sensor, follow these general steps:1. Choose a suitable location - The sensor should be installed at a point in the hydraulic system that provides an accurate representation of the system pressure. Typically, the hydraulic high sensor is installed near the pump or at the point where the hydraulic fluid enters the system.2. Prepare the installation site - First, clean the mounting area where the sensor will be installed. This is important to ensure the sensor mounting surface is clean, dry, flat, and free from debris that may affect the sensor's performance.3. Mount the sensor - Once the site is ready, mount the sensor properly. Use a torque wrench with the specified torque, to avoid damaging the sensor or the hydraulic fitting.4. Connect the sensor to the system - Connect the Pressure Sensor to the hydraulic system by attaching the hydraulic hose or pipe to the sensor's ports. Ensure that the hoses or pipes are connected correctly and securely to avoid leakage, possible damage, or injury. 5. Test the hydraulic high sensor and system - Once the sensor is installed, the system and the sensor should be tested to determine whether it is working correctly. Use a multimeter or other instrumentation to verify voltage and check the sensor's output signal. Monitor hydraulic pressure readings to check if they are within the recommended limits. Note that it is always important to follow the manufacturer's instructions for installing the specific hydraulic pressure sensor you have. The steps above should be used as general guidelines only.